The original stringer was glued to the plywood, so I had to cut out a relief on the replacement to allow the plywood to fit flush with the nose end of the stringers.
Here is a section near the nose on the port side. Quite a bit more plywood had been ripped out there. I decided to fill it mostly with the silica-thickened epoxy I am using to glue things back together. The masking tape is holding the glue in place because it is much "runnier" than wood-flour-thickened epoxy. That low spot will be filled with wood flour/epoxy later.
Bowsprit restored! All it needs now is four or five coats of varnish.
The breasthook and stringers all glued in place. Three or four coats of paint and Gaia is ready to be re-rigged.
Painting finished. I have repaired and replaced the old tabernacle so I can get the boat back on the water. The tabernacle is constructed of red oak and was always intended for replacement at some point. I have purchased white oak for the purpose and will begin construction of the new tabernacle sometime soon. I'm glad I bolted the tabernacle in instead of gluing it. If I had glued it I would have badly damaged the front of the cabin removing it. I plan to also bolt the new one and not glue it. I don't see any point in gluing it--all the side pressure on the mast is taken up by the jib stay and shrouds. If one of those breaks under extreme stress, the tabernacle will probably sustain the most damage, and again, it can be unbolted and replaced.
The bowsprit is varnished and ready to go. I decided to varnish the tiller too--it takes a beating. My plan is to fashion a new tiller from the white oak also, but the old one will serve just fine for now.
So all I have to do now is re-rig and bend on the sails and she's ready for the water!
No comments:
Post a Comment